If you are unsure which joint system you have:
- All ‘bottom loading’ X-POLE sets (screw adjuster at the bottom) use X-JOINT’s.
- Poles with the screw adjuster at the top use screw extensions. (For further details on extensions for these pole sets, please contact us on 44 (0) 208 449 4400).
Important Note: X-JOINT’S are not supplied with the extensions. Some extensions will require an X-JOINT unit to be purchased in addition. However, as every X-POLE set is supplied with 3 X-JOINT’s, additional joint’s may not be needed. Please check what joints are required to match the extensions being used.
Installed only at the top of the pole, in descending size order, the extensions are connected using X-JOINT’s.
X-POLE extensions come in varying sizes to allow expansion of the X-POLE up to 3370mm (132″, 11ft). Installed at the top of the pole they connect together for maximum strength, stability and smoothness.
Sizing – The most important points to remember when choosing an extension is to select the correct size to minimise the adjuster length and always use one longer extension as opposed to two.
Always check your ceiling measurement before ordering extensions.
100mm and 125mm Extensions are used with a 180mm X-JOINT’s only.
For 40mm poles above 3050mm (120\” 10ft) please contact the sales office for advice.
The 100mm extension can only be used with SPORT Poles (NS) and not with XPERT (NX) or XPERT Pro (PX). This extension can also only be used with the 180mm X-JOINT.